113.7-6-60
GN 113.7 Goupilles de verrouillage à bille
En stock Toutes les tailles et variantes de GN 113.7
🔒 Prix, stock en temps réel & téléchargements CAO
Connectez-vous pour voir vos prix et le stock, télécharger les fichiers CAO et commander directement en ligne.
Se connecter Demander un compte
Fiche technique
Caractéristiques techniques
- Code
- GN 113.7-6-60
- d1 -0.04/-0.08
- 6
- l1 +0.6
- 60
- d2
- 7
- d3
- 40
- d4
- 13.5
- l2 ±1
- 7.1
- l3
- 25
- m
- 15.5
- Location
bore H11 - 6
- Load in kN ≈
Load capacity in kN ≈
Double sided
shearing resistance
according DIN 50141
(breaking strength) - 21
- 24
Pin
Stainless steel AISI 303
T-Handle
Plastic (Polyamide PA)
- Black
- Temperature resistant up to 80 °C
Balls
Stainless steel AISI 420C
Pressure spring
Stainless steel German Material No. 14565
Ball lock pins GN 113.7 are used for quick fixing, connecting and locking of various parts and workpieces. A typical application is locating pins which have often to be removed and installed again.
By pressing the spring loaded push button both balls are unlocked and by releasing it, the balls are locked again.
The technical appendix contains the load capacities for the double-sided shearing resistance (breaking strength).
Information
The load capacities specified in the table for the double sided shearing resistance (breaking strength) have been calculated or theoretically defined on the basis of DIN 50141.
At the same time, the endangered bolt cross-section S, according to a nearby sketch, was considered in two shear planes before breakage.
The details given on load rating are non-binding guide values without any liability. In general, they do not constitute a warranty of condition.
The user must determine whether the product is suitable for the intended purpose. Environmental factors can influence the specified values.
An appropriate safety factor must be taken into account in the design.