GN 131.2-ALConnecteurs d'actionneur linéaire bidirectionnel

Aluminium

Aluminium / Acier inoxydable , pour système à deux axes

Technical datasheet

GN 131.2-AL

Réinitialiser

Code	d₁ - d₂ without sleeve bearing	d₁ - d₂ with sleeve bearing	d₃ Mounting screws on the drive key	k Clamping length	l₁	m		Accessory Recom. hand lever GN 911 for z l₂

GN 131.2-G18-G18-2-SW	-	G 18 - G 18	M 3	25	64	20	M6-20	45 63	62

Identification no.

No. 2: With 2 stainless steel socket cap screws DIN 912

Aluminum

Powder coated

Black, RAL 9005, textured finish SW

Stainless Steel AISI CF-8 NI

Matte shot-blasted

Only with sleeve bearing

Sleeve bearing

Plastic (PTFE)

Socket cap screws DIN 912

Stainless steel AISI 304

Hex nuts DIN 985

Stainless steel AISI 304

Self-locking via polyamide ring

Two-way linear actuator connectors GN 131.2 are based on two-way connector clamps. The additionally provided mounting holes are used to connect to the drive key of a linear actuator. Bores with the designation „G“ are equipped with sleeve bearings.

With the screw locations z, the play of the guide bores d₁ / d₂ can be adjusted or the linear actuator connectors can be clamped after adjustment.

For clamping without tools, the socket cap screws can be replaced by the adjustable hand levers GN 911 /GN 911.3 listed in the table as accessories.