GN 146.15-AFlanged Linear Actuator Connectors

Without seals

Stainless Steel, with 4 Mounting Holes

  • Icons/__logo__INOX__.png
  • Icons/__logo__RoHS__.png
Without seals
Without seals
Without seals
GN 146.15-A
Without seals
With seals
GN 146.15-B
With seals

GN 146.15-A

Reset
Catalogue
d1
Bore with sleeve bearing
b
d2
d3
d4
Mounting screws
on the drive key
k Clamping length
l1
m
t
x1
x2
y1
GN 146.15-G30-A-4
G 30
22
6.5
37
M 4
40
66
30
7
52
35
70
GN 146.15-G50-A-4
G 50
30
10.7
60
M 6
65
98.5
50
9
92
62
128

Types

  • Type A: Without seals
  • Type B: With seals

Identification no.

  • No. 4: With stainless steel cap nut DIN 917

Stainless steel AISI CF-8

Matte shot-blasted

Sleeve bearing

Plastic (PTFE)

Carriage bolt DIN 603

Stainless steel

Cap nuts DIN 917 / Washers

Stainless steel

Seals

  • Sealing disks

Plastic (Polyacetal POM)

  • Spacer ring

Silicon, 40 ... 60 Shore A

Flanged linear actuator connectors GN 146.15 are based on flanged connector clamps. The additionally provided mounting holes are used to connect to the drive key of a linear actuator. Bores with the designation G are equipped with sleeve bearings.

With the screw location z, the play of the guide bores d1 can be adjusted or the linear actuator connectors can be clamped after adjustment. Type B is equipped with seals at the screw locations.

For quick clamping without tools, the cap nut can be replaced by the adjustable hand levers GN 911.3 listed in the table as accessories.

Related products
Without seals

GN 146.16-A

Flanged Linear Actuator Connectors Stainless Steel, with 2 Mounting Holes
with Threaded Bushing

GN 911.3

Adjustable Stainless Steel Hand Levers with Threaded Bushing / Threaded stud, for Tube Clamp Connectors / Linear actuator connectors