Technical datasheet
GN 132.15-BTwo-Way Linear Actuator Connectors
With seals
for One-Axis System, Stainless Steel
GN 132.15-B
|
Catalogue
|
d1 - d2
with sleeve bearing |
b
|
d3
|
d4
Mounting screws on the drive key |
k Clamping length
|
l1
|
m
|
|
Accessory
Recom. hand lever GN 911.3 for z l2 |
|
|---|---|---|---|---|---|---|---|---|---|---|
|
|
|
|
|
|
|
|
|
|
|
|
|
GN 132.15-G30-B30-B-4
|
G30 - B30
|
22
|
37
|
M 4
|
40
|
104
|
33
|
M 8
|
63 78
|
296
|
|
GN 132.15-G50-B50-B-4
|
G50 - B50
|
30
|
60
|
M 6
|
65
|
150
|
53
|
M 10
|
78 92
|
970
|
Types
- Type A: Without seals
- Type B: With seals
Identification no.
- No. 4: With 2 stainless steel cap nuts DIN 917
Stainless steel AISI CF-8
Matte shot-blasted
Sleeve bearing
Plastic (PTFE)
Carriage bolt DIN 603
Stainless steel
Cap nuts DIN 917 / Washers
Stainless steel
Seals
- Sealing disks
Plastic (Polyacetal POM)
- Spacer ring
Silicon, 40 ... 60 Shore A
Two-way linear actuator connectors GN 132.15 are based on two-way connector clamps. The additionally provided mounting holes are used to connect to the drive key of a linear actuator. Bores with the designation G are equipped with sleeve bearings.
With the screw locations z, the play of the guide bore d1 can be adjusted or the linear actuator connectors can be clamped after adjustment. Type B is equipped with seals at the screw locations.
For quick clamping without tools, the cap nuts can be replaced by the adjustable hand levers GN 911.3 listed in the table as accessories.
- Adjustable Hand Levers GN 911.3
Related products
