GN 192.15-AT-Angle Linear Actuator Connectors

Without seals

Stainless Steel

  • Icons/__logo__INOX__.png
  • Icons/__logo__RoHS__.png
Without seals
Without seals
Without seals
GN 192.15-A
Without seals
With seals
GN 192.15-B
With seals

GN 192.15-A

Reset
Catalogue
d1
Bore with sleeve bearing
d2
Bore
b
d3
Mounting screws
on the drive key
k1 Clamping length
k2 Clamping length
l1
l2
m
z1
Screw location
z2
Screw location
Accessory
Recom.
hand lever
GN 911.3 for z1
l3
GN 192.15-G30-B30-A-4
G 30
B 30
22
M 4
37
42
96
35
60
M 8
M 8
63 78
GN 192.15-G50-B50-A-4
G 50
B 50
30
M 6
65
75
151.5
48.5
103
M 10
M 10
78 92

Types

  • Type A: Without seals
  • Type B: With seals

Identification no.

  • No. 4: With 2 stainless steel cap nuts DIN 917

Stainless steel AISI CF-8

Matte shot-blasted

Sleeve bearing

Plastic (PTFE)

Carriage bolt DIN 603

Stainless steel

Cap nuts DIN 917 / Washers

Stainless steel

Seals

  • Sealing disks

Plastic (Polyacetal POM)

  • Spacer ring

Silicon, 40 ... 60 Shore A

T-angle linear actuator connectors GN 192.15 are based on T-angle connector clamps. The additionally provided mounting holes are used to connect to the drive key of a linear actuator. Bores with the designation G are equipped with sleeve bearings.

With the screw locations z2, the play of the guide bore d1 can be adjusted or the linear actuator connectors can be clamped after adjustment. Type B is equipped with seals at the screw locations.

For quick clamping without tools, the cap nuts can be replaced by the adjustable hand levers GN 911.3 listed in the table as accessories.

Related products
with Threaded Bushing

GN 911.3

Adjustable Stainless Steel Hand Levers with Threaded Bushing / Threaded stud, for Tube Clamp Connectors / Linear actuator connectors